The LO-PRO™ Junction Box is a low profile and rugged steel enclosure designed for use with our 20W, 35W, and 60W 12V Drivers. This power supply enclosure is ETL listed to UL STD 508A, which means that it complies with electrical codes requiring junction boxes to separate household and low voltage wiring within the same enclosure. So it's the ideal accessory for installing our 12V Drivers in compliance with these building codes. This low voltage accessory is an essential piece in a hard-wired LED light installation, whether with or without an LED dimmer switch.
The LO-PRO Junction Box is for use with the following 12V Drivers only:
Designed for contractor installation, this enclosure features integral mounting holes with four 0.20 inch mounting holes for surface mounting. The ETL Listed enclosure also features inside mounting hole positions that hold compatible power supplies securely. This NEMA 1 steel indoor enclosure is made of lightweight but strong steel with a protective black powder-coated finish.
Note: state and local building codes vary, see electrical codes in your region for accurate installation and usage guidelines.
Reviewed on June 18, 2013 by Leo
ETL listed to UL STD 508A
Weight: 0.80 lb.
Length: 7.7 in.
Width: 4.9 in.
Height: 1.8 in.
Housing: NEMA 1 steel indoor enclosure
Knockouts: 4 x 0.5 in. NPT
Compatible with: 20W, 35W, 60W 12V Drivers
Voltage rating: max. 600V AC
Finish: powder-coated black
This enclosure must be installed in accordance with the National Electrical Code, ANSI/NFPA 70, where the ambient temperature does not exceed 40ºC (104ºF) maximum